Introduction to Spectroscopy: Analysis of Copper Ore

You will then analyze the copper content in unknown samples taken from the two drill sites (A and B). 1) Use a cuvette filled 2/3 full with deionized water to calibrate the Spec-20.

US3827557A - Method of copper sulfide ore flotation ...

A novel flotation promoter used in the concentration of copper bearing ores for the efficient selective flotation of copper values, including chalcopyrite, with suppression of iron pyrites; the promoter comprising a sodium sulfate of an aliphatic hydrocarbon having a carbon chain in excess of 12 carbons and chemically combined with at least one mole of the C2-C3 alkylene oxides.

Copper extraction - Wikipedia

Sulfide ores. Secondary sulfides – those formed by supergene secondary enrichment – are resistant to sulfuric leaching.These ores are a mixture of copper carbonate, sulfate, phosphate, and oxide minerals and secondary sulfide minerals, dominantly chalcocite but other minerals such as digenite can be important in some deposits.. Supergene ores rich in sulfides may be concentrated using ...

Chapter 6 Copper Production Technology

Copper ores 0.2-6.0 Copper ore, other minerals, waste rock0.2-6.0 (gangue) Copper minerals,b iron and other metallic0.5-6.0 pyrites, byproducts, andgangue Solution of copper and leaching agent20-50 (water orHAO.) Copper, iron (0.2-2.00/0), trace amounts of85-90 silica and aluminum oxides, and oxygen Organic solvent and pregnantIeachate; 25-35

Copper Sulfate - Agricultural Marketing Service

The production of copper sulfate, using copper ore as 46 the starting raw material, is rarely utilized. The bulk of production comes from nonferrous scrap. The scrap 47 metal is refined and dissolved in dilute sulfuric acid. The saturated solution is allowed to cool and the 48 copper sulfate crystals form.

Colourimetric determination of copper ore | Experiment ...

Samples of copper ore, such as malachite, could be shown, if available. For the second question, work out the concentration of copper in, say, test tube 3: Concentration Cu (as Cu 2+) = 4/10 x 1 M = 0.4 M. Work out the concentration of copper ions when 5 g of copper carbonate is dissolved and made up to 100 cm 3 of solution (formula mass of ...

Gold-copper ores - ScienceDirect

The theoretical reagent consumption for the copper sulfate route expressed as kg/kg of copper recovered is: sulfuric acid, 4.19; oxygen, 0.15; caustic soda, 2.64 and quicklime (equivalent at 78% CaO), 2.37. In the sulfide variation, copper can be recovered as cuprous sulfide by acidifying to a pH value of <3 and adding sodium sulfide.

12.3 Primary Copper Smelting

copper sulfate (Cu2SO4) and sulfuric acid (H2SO4). The copper anode is dissolved and deposited at the cathode. As the copper anode dissolves, metallic impurities precipitate and form a sludge. Cathode copper, 99.95 to 99.96 percent pure, is then cast into bars, ingots, or …

Experiment 12: Make-Up Experiment Copper Analysis by ...

(e) mass of copper Average % copper content (f) % copper content 12B Exercise Copper(II) sulfate forms a hydrate which contains 36.1% by mass water. Since the only component (other than H2O and Cu 2+) is the sulfate ion, SO 4 2–, we can now determine the complete formula of the hydrated copper(II) sulfate. Do this determination.

Copper(II) sulfate - Wikipedia

Treatment of Mixed Sulfide Oxide Ores of Copper

copper sulfate TAP to NOSB k6 final for Web

Copper sulfate solutions are derived from the processing of copper ores, 41 which are electrorefined or electrolytically processed to produce copper metal. The pentahydrate is made by dissolving 42 scrap copper in hot concentrated sulfuric acid (generating sulfur dioxide) or by air oxidation of …

Copper Ores

Chalcanthite these are actually artificially grown copper sulphate crystals up to 13mm long on a 42mm limestone matrix. Weight 18g. (Hydrated Copper Sulphate, CuSO 4.5H 2 0) 2804. Cerussite, it shows the sheen like crystal formation. Size 47 x 26mm, weight 116g. (White Lead Ore, PbCO 3) 2759

Student Handout Spectrophotometric Determination of Cu

• measure the absorbance of the ore sample solutions. • use the graph to determine the concentration of copper in the ore sample solutions. Materials Per lab team Spectrophotometer (Spec-20 or Genesys-20) Cuvettes (6 or more) A set of Cu2+ (aqueous copper(II) sulfate solution) standards (5.00 g/L, 4.00 g/L,

Mining Industry | Copper Sulfide Ore and Flotation Process ...

1 Types of copper sulfide ore (1) Single copper mineral Its ore characteristic is relatively simple, and the only useful component that can be recycled is copper. The gangue minerals are mainly quartz, carbonate and silicate. (2) Copper-sulfur ore Called copper-bearing pyrite. In addition to copper minerals, iron sulfide can be recovered, and the main mineral of sulfur is pyrite.

Copper sulfate | CuSO4 - PubChem

Copper sulfate | CuSO4 or CuO4S | CID 24462 - structure, chemical names, physical and chemical properties, classification, patents, literature, biological activities ...

Leaching characteristics of copper refractory ore in ...

Refractory copper ores (CROs) in central Africa contain copper minerals that are locked up in a micacious solid matrix or associated with carbonate, sulfide and phosphate minerals. Several researchers have reported that the recovery of copper from CRO material by an acid-leaching process is not economically feasible, due to the presence of excess gangue-acid-consuming minerals such as …

US3886257A - Sulfate leaching of copper ores using silver ...

Copper is oxidatively leached from a copper bearing ore in the presence of a catalytic amount of silver ions to decrease leaching times. The oxidative agent may be ferric sulfate, dilute sulfuric acid in the presence of added oxygen, or concentrated sulfuric acid.

Copper | Cu - PubChem

Copper is a metal that occurs naturally throughout the environment, in rocks, soil, water, and air. Copper is an essential element in plants and animals (including humans), which means it is necessary for us to live. Therefore, plants and animals must absorb some copper from eating, drinking, and breathing. Copper is used to make many different kinds of products like wire, plumbing pipes, and ...

Copper Sulfide - an overview | ScienceDirect Topics

The leaching of copper sulfide and copper oxide ores entails partial dissolution to cupric sulfate with sulfuric acid and iron sulfate. The presence of pyrites in many ore deposits, and its reaction with water and oxygen to form iron sulfate and sulfuric acid, creates an important source of acid.

Copper Sulfate General Fact Sheet

Copper sulfate is an inorganic compound that combines sulfur with copper. It can kill bacteria, algae, roots, plants, snails, and fungi. The toxicity of copper sulfate depends on the copper content. Copper is an essential mineral. It can be found in the environment, foods, and water.

(PDF) LEACHING OF A ROASTED COPPER SULFIDE ORE | …

In roasting, copper was mainly formed to soluble sulfate by The copper sulfide ore was roasted at 900 degrees C water or dilute acid after roasting. Mostly this for one hour. The total copper (% CuO and CuSO4) method is applied to pretreatment of copper was determined through the analysis of copper and concentrate with high percentage of sulfur.

BULK MATERIAL DENSITY TABLE - Tapco, Inc

Copper Ore 120-150 Copper Ore, Crushed 100-150 Copper Sulfate (Bluestone) 75-85 Copperas (See Ferrous Sulfate)-Copra Cake, Ground 40-45 Copra Cake, Lumpy 25-30 Copra, Lumpy 22 Copra, Meal 40-45 Page 2 of 7 - Scroll for more...

What is the difference between sulfide ores and oxide ores ...

This trickles slowly through the ore dissolving copper to form copper sulfate. What are the different types of copper ore? There are two main copper ore types of interest, copper oxide ores and copper sulfide ores. Both ore types can be economically mined, however, the most common source of copper ore is the sulfide ore mineral chalcopyrite ...

Copper Sulfate Prices | Historical & Current | Intratec.us

Copper oxide ores + sulfuric acid (salt formation) Copper ore leachant + sulfuric acid (solvent extraction/ salt formation) price 3 inorganic-chemicals copper-sulfate 1 3 360 Copper II Sulfate (a.k.a. Cupric Sulfate) is an inorganic compound that can be found in many forms, with the pentahydrate being the most common of them. The pentahydrate ...

Recovery of Copper from Copper Sulfide Concentrate by ...

As copper turned into copper sulfate during sulfation roasting, it is important that how much sulfur removed and remained in the roasted ore. Seen from Figure 1, the transformation ratio of sulfur dioxide enhanced from 75% to 92% when the roasting

[On carcinogenic effects of sulfate copper and nickel ore]

Abstract. Underground mines are places for extraction of three types of copper and nickel sulfide ores: rich, copper and incorporated--those three ones differ in mimeralogic and chemical contents. Experimental evaluation of carcinogenic effects obtained during intratracheal administration of copper and incorporated ores indicates the certain ...

copper | Uses, Properties, & Facts | Britannica

Copper is commercially produced mainly by smelting or leaching, usually followed by electrodeposition from sulfate solutions. For a detailed treatment of the production of copper, see copper processing.The major portion of copper produced in the world is used by the electrical industries; most of the remainder is combined with other metals to form alloys.

Treatment of Mixed Sulfide Oxide Ores of Copper

Open pit: 90% of ore is mined by this method. Ores near the surface can be quarried after removal of the surface layers. The ore is treated with dilute sulfuric acid. This trickles slowly through the ore dissolving copper to form copper sulfate. The copper is recovered by electrolytic refining.

From Ore to Finished Product - Copper

Copper - From Beginning to End. Copper is a major metal and an essential element used by man. It is found in ore deposits around the world. It is also the oldest metal known to man and was first discovered and used about 10,000 years ago. And as alloyed in bronze (copper-tin alloy) about 3000 BC, was the first engineering material known to man.

How to Make Copper Sulfate - ThoughtCo

Make Copper Sulfate. Fill a jar or beaker with 5 ml concentrated sulfuric acid and 30 ml of water. If your sulfuric acid solution is already diluted, add less water. Set two copper wires into the solution so that they are not touching each other. Connect the wires to a 6-volt battery.

Treatment of Mixed Sulfide Oxide Ores of Copper

Ferric sulfate (or even better, ferric chloride, where salt is easily available) has many possibilities in connection with a mixed copper ore. It will attack and oxidize the sulfides and will dissolve the oxidized minerals and the artificial oxides resulting from the attack on the sulfides.

Sulfate leaching of copper ores using silver catalyst ...

Copper is oxidatively leached from a copper bearing ore in the presence of a catalytic amount of silver ions to decrease leaching times. The oxidative agent may be ferric sulfate, dilute sulfuric acid in the presence of added oxygen, or concentrated sulfuric acid.

How to Kill a Tree with Copper Sulfate | Hunker

Copper sulphate is a poison often used to discourage tree roots from growing into vulnerable areas such as sewer lines. It can, however, kill a whole tree if it is properly applied. Although you may be able to kill a tree by putting copper sulfate on the ground around it, the sulphate is toxic to the water supply and the ground, so this ...

: copper sulfate

Root Destroyer – 2lbs of Pure Copper Sulfate Crystals - Root Killer for Sewer & Pipe Lines- Stops New Growth – Safe for all Plumbing. 4.4 out of 5 stars 2,169. $18.99 $ 18. 99. $17.09 with Subscribe & Save discount. Get it as soon as Fri, Nov 5. FREE Shipping on orders over $25 shipped by Amazon.